Step 5 - Setting the Operating System

Your Navigator needs to know which operating system you are using on your Home Theater PC (HTPC): Windows, Mac, or PS3. Each OS requires slightly different commands in order properly operate the applications. By setting your Navigator to the right OS, your Navigator will know which signals
to send to your HTPC.

The remote ships in Windows mode from the factory. Therefore this step can usually be skipped by anyone using a Windows OS. Setting the OS on your Navigator is easy.

• Ensure you have the USB Receiver plugged into the HTPC you intend to control.

• Press and hold at the same time, the touchpad and button until all buttons blink
  twice. This indicates that your remote is ready to be programmed.
  • The Navigator will continue to blink once every second 7 more times to indicate
    that it is waiting for instructions.
  • After the seventh time, the power button will flash red and the remote will return
    to its initial state.

• Press the top right, center, or left buttons located around the edge of the touchpad, as
  indicated below, to select your operating system.
  • If the command was successfully programmed, the Power button will flash Amber
    repeatedly.