The below procedure details how to recalibrate the touch surface of the Navigator.

In some cases, this may be necessary in the event that the cursor begins to act sporadically or appears to be too responsive or unresponsive. This can occur due to drastic changes in humidity, temperature, and other environmental factors.

Please read all steps below before proceeding.

Step 1

First you will need to put the Navigator into programming mode.

• Press and hold, at the same time, the touchpad button and the button until all buttons blink twice.
  This indicates that the device is in programming mode.
  • The Navigator will continue to blink once every second, a total of 7 times, to indicate that it is waiting for instructions.
  • After the 7th time, if no command is received or an incorrect command is received, the power button will flash Red and the remote will return to its previous state.

Step 2

• Press the Play/Pause button once and immediately place the Navigator down on a flat surface away from your hands or any metal object.
  • All buttons will rapidly flash to indicate the calibration process has started
  • Wait about 3 seconds until you see all buttons rapidly flash again, and then the Power button will flash 3 times as well. This indicates that the calibration process is complete

Demonstration Video Below